Mora Knife Forced Patina How To Project

Published on April 4, 2017
Duration: 12:00

This guide details how to apply a forced patina to a Morakniv Companion Carbon Steel knife, a technique favored by survivalists and outdoorsmen for aesthetics and rust protection. The process involves degreasing the blade, repeatedly oxidizing it in heated apple cider vinegar, and finally sealing the patina with oil. The expert instruction highlights the importance of a 90-degree spine for fire-starting utility.

Quick Summary

Applying a forced patina to a Morakniv carbon steel knife enhances its look and protects against rust. The process involves degreasing with isopropyl alcohol, repeatedly oxidizing the blade in heated apple cider vinegar for about 10 minutes per cycle, and finally sealing the patina with 3-IN-ONE oil. Modifying the spine to 90 degrees is also recommended for fire-starting.

Chapters

  1. 00:36Introduction to Mora Knives
  2. 01:40Sourcing and Pricing
  3. 02:41Spine Modification
  4. 04:03Patina Preparation
  5. 05:15The Oxidation Process
  6. 09:14Final Finishing

Frequently Asked Questions

What is the purpose of a forced patina on a Morakniv carbon steel knife?

A forced patina serves two main purposes: it enhances the aesthetic appeal of the carbon steel blade with a unique finish and provides a protective layer against rust and corrosion, which is crucial for outdoor and survival use.

What materials are needed to apply a forced patina to a knife?

You will need isopropyl alcohol for degreasing, apple cider vinegar as the oxidizing agent, a glass container, a clamp to suspend the knife, and a heat source to boil the vinegar. Finally, 3-IN-ONE oil is used for protection.

How do you prepare a Morakniv knife for a forced patina?

First, thoroughly clean and degrease the knife blade, ideally with isopropyl alcohol, to ensure an even chemical reaction. If desired, modify the spine to a 90-degree angle for fire-starting utility.

What is the process for oxidizing the knife blade?

Heat apple cider vinegar to a boil, then submerge the degreased blade for about 10 minutes per cycle. Repeat this process, cleaning the blade between soaks, until the desired dark grey patina is achieved.

More Gunsmithing & DIY Videos You Might Like

More from SensiblePrepper

View all →