PSA Rifle DEAD at 2k Rounds

Published on September 19, 2024
Duration: 0:50

This review details a Palmetto State Armory (PSA) H&R M16A2 build that experienced a Bolt Carrier Group (BCG) failure, specifically blown gas rings, after only 2,000 rounds. The speaker demonstrates the BCG failing the 'stand test' and expresses disappointment in the premature wear of PSA/H&R components. The review highlights potential reliability concerns with this specific build's components.

Quick Summary

A Palmetto State Armory (PSA) H&R M16A2 build experienced a critical failure at 2,000 rounds. The Bolt Carrier Group (BCG) failed the 'stand test' due to blown gas rings, indicating premature wear and potential reliability concerns with these components.

Chapters

  1. 00:00Rifle Overview & Round Count
  2. 00:15BCG Failure: Gas Ring Test
  3. 00:35Conclusion & Audience Feedback

Frequently Asked Questions

What caused the PSA H&R rifle to fail after 2,000 rounds?

The rifle's Bolt Carrier Group (BCG) failed due to blown gas rings. This was identified when the BCG could not pass the 'stand test,' indicating premature wear on critical components after only 2,000 rounds.

What is the 'stand test' for a BCG?

The 'stand test' is a diagnostic method where the BCG is placed upright on its bolt. If the carrier immediately slides down, it indicates worn or blown gas rings, compromising the seal and function of the BCG.

What components were involved in the PSA rifle failure?

The failure involved Palmetto State Armory (PSA) and Harrington & Richardson (H&R) components. Specifically, the bolt carrier group's gas rings failed prematurely on an H&R M16A2 build with a PSA upper and Colt lower.

How many rounds did the PSA rifle have before failure?

The PSA H&R M16A2 rifle experienced BCG failure with blown gas rings at approximately 2,000 rounds. The speaker had just completed a 1,000-round session that day, bringing the total to this mark.

Related News

All News →

More Reviews Videos You Might Like

More from Trench Grenade

View all →