Body Armor vs 50 Shotgun Slugs

Published on September 5, 2014
Duration: 7:55

This video details a test by Matt Carriker of DemolitionRanch, an experienced individual with a veterinary background, assessing the durability of an AR500 steel body armor plate against 50 shotgun slugs. The plate, featuring a rubberized spall guard, was subjected to various 12-gauge slug loads. Despite significant deformation and complete removal of the spall coating in the impact area, the steel plate itself did not crack or show signs of penetration after enduring all 50 rounds, demonstrating the resilience of AR500 steel against repeated high-impact shotgun slugs.

Quick Summary

An AR500 steel body armor plate was tested against 50 12-gauge shotgun slugs fired into a single spot. The plate endured all impacts without penetration or cracking, though its rubberized spall coating was completely removed and the steel itself became severely bent and dented. This demonstrates the high durability of AR500 steel against repeated shotgun slug impacts.

Chapters

  1. 00:00Introduction and Experiment Premise
  2. 00:45Test Setup and Ammunition Details
  3. 01:45First Rounds of Shooting
  4. 02:24Mounting Challenges and More Shots
  5. 03:30High Power Slug Impact
  6. 04:50Final Inspection and Results
  7. 06:42Conclusion

Frequently Asked Questions

How many shotgun slugs did the AR500 steel body armor plate withstand?

The AR500 steel body armor plate was tested with 50 rounds of 12-gauge shotgun slugs fired into the same spot. Despite significant deformation and the complete removal of its spall coating, the plate itself did not crack or show any signs of penetration after enduring all 50 impacts.

What type of ammunition was used to test the AR500 steel body armor?

The test utilized 12-gauge shotgun slugs, including high brass, 2.75-inch loads. The ammunition consisted of low-recoil, standard, and magnum varieties, with most slugs weighing 1 ounce and some weighing 1.25 ounces.

What happened to the spall guard coating during the test?

The rubberized spall guard coating began to separate from the steel core after the first few impacts. By the end of the test, after approximately 50 shotgun slug impacts, the coating was completely removed from the area of impact on the AR500 steel plate.

Did the AR500 steel plate penetrate after being shot with 50 shotgun slugs?

No, the AR500 steel plate did not penetrate or crack after being subjected to 50 rounds of 12-gauge shotgun slugs. While the plate became severely bent and showed significant dents, its structural integrity held, preventing any breakthrough.

More Tactical & Gear Videos You Might Like

More from DemolitionRanch

View all →