HALEY STRATEGIC - How to adapt your USMC Gen III PLATE CARRIER to accept PLACARDS

Published on August 10, 2024
Duration: 1:57

This guide demonstrates how to adapt a USMC Gen III plate carrier to accept chest rig placards using two Quasm buckles. The process involves freeing up the front load-bearing panel, stuffing it into the kangaroo pouch, and then weaving the Quasm buckles through the 1-inch webbing found beneath the MOLLE field. This allows for quick attachment and detachment of placards, emphasizing that gear should work around the user.

Quick Summary

To adapt a USMC Gen III plate carrier for placards, install two Quasm buckles. Disengage the front load-bearing panel and stow it. Weave the Quasm buckles through the 1-inch webbing under the MOLLE field on the front plate bag, securing the bottom loop. This allows for quick attachment of chest rigs or placards.

Chapters

  1. 00:14Introduction: Adapting Gen III Plate Carrier
  2. 00:21Freeing Up Load Bearing Panel
  3. 00:38Locating 1-Inch Webbing
  4. 00:51Installing Quasm Buckles
  5. 01:01Securing Bottom Quasm Loop
  6. 01:17Attaching Chest Rig/Placard
  7. 01:30Conclusion: Gear Adaptability

Frequently Asked Questions

How do I attach a placard to a USMC Gen III plate carrier?

To attach a placard, you'll need two Quasm buckles. First, disengage and stow the front load-bearing panel. Then, weave the Quasm buckles through the 1-inch webbing found under the MOLLE field on the front plate bag, securing the bottom loop. Finally, connect your placard's buckles to the installed Quasm buckles.

What hardware is needed to adapt a USMC Gen III plate carrier for placards?

You will need two Quasm buckles to adapt a USMC Gen III plate carrier for placards. These buckles are installed onto the 1-inch webbing located beneath the MOLLE field on the front of the plate carrier, providing attachment points for chest rigs or placards.

Where can I find the attachment points for placards on a USMC Gen III plate carrier?

On the USMC Gen III plate carrier, the primary attachment points for placards are created by installing Quasm buckles. These buckles are woven through the 1-inch webbing that is situated directly underneath the MOLLE field on the front plate bag.

Related News

All News →

More Tactical & Gear Videos You Might Like

More from Haley Strategic Partners

View all →