Installation - Miculek Revolver Grips

Published on September 23, 2022
Duration: 9:45

This guide details the installation of Jerry Miculek's signature revolver grips, manufactured by Hogue. It covers the design philosophy, material choices (Pau Ferro hardwood), and provides step-by-step instructions for both round butt and square butt Smith & Wesson frames. Key installation challenges and troubleshooting tips are also addressed, emphasizing careful handling to prevent damage.

Quick Summary

Jerry Miculek's revolver grips, made by Hogue from Pau Ferro hardwood, feature a no-finger-groove design for consistent indexing and a universal feel across S&W K, L, and N-frames. Installation involves fitting the grip from the bottom, especially for round butt frames, and securing it with a provided screw, with minimal tools required.

Chapters

  1. 00:15Introduction to Miculek Grips
  2. 00:25Grip Design Philosophy
  3. 01:14Grip Material and Features
  4. 01:49Installation Challenges & Tools
  5. 02:10Revolver Frame Types
  6. 02:37Fitting Grips to Frame Types
  7. 03:10Installing Round Butt Grip
  8. 04:55Final Round Butt Installation
  9. 05:57Installing Square Butt Grip
  10. 07:22Square Butt Grip Cutaway
  11. 08:03Troubleshooting & Tips

Frequently Asked Questions

What are the key design features of the Miculek revolver grips?

The Miculek grips lack finger grooves for consistent indexing and are shaped to make S&W K, L, and N-frame revolvers feel similar. They are also relatively thin for better recoil control and feature a two-piece Pau Ferro hardwood construction.

What tools are needed to install Miculek revolver grips?

Minimal tools are required, typically a screwdriver, a small hammer (optional), and possibly a file if minor adjustments are needed. A hollow-ground tip screwdriver is recommended to prevent damaging the grip stock.

How do you install Miculek grips on a round butt Smith & Wesson revolver?

First, test fit the grip without the stirrup by sliding it up from the bottom. Then, install the stirrup with its roll pin centered on the frame. Slide the grip onto the frame from the bottom, ensuring it's fully seated, and secure it with the screw.

What is the main difference in installation between round butt and square butt Miculek grips?

Round butt grips require more wood in the back to fill the frame and need careful fitting from the bottom up. Square butt grips are generally easier to install, with the main consideration being the centering of the frame pin before sliding the grip on.

What material are the Miculek revolver grips made from?

The Miculek revolver grips are manufactured by Hogue and made from Pau Ferro, a hardwood known for its beautiful grain and excellent gluing properties, ensuring durability for the two-piece stock.

Related News

All News →

More Gunsmithing & DIY Videos You Might Like

More from Lena Miculek - Trigger Tribe

View all →