N-PAP Disassembly - Burst Review Takedown 002

Published on May 22, 2013
Duration: 3:37

This video provides a step-by-step guide on how to disassemble and reassemble a Century Arms N-PAP rifle chambered in 7.62x39mm. The instructor emphasizes safety throughout the process, starting with confirming the firearm is unloaded. Key steps include removing the dust cover, recoil spring assembly, bolt carrier, and bolt. Reassembly follows the reverse order, with specific attention paid to aligning the gas tube and securing the dust cover.

Quick Summary

To safely disassemble a Century Arms N-PAP rifle, begin by ensuring it's unloaded: remove the magazine, disengage the safety, and rack the action. Then, press the button on the rear of the dust cover to remove it, followed by the recoil spring assembly. The bolt carrier can then be removed, and the bolt separated from it by pressing inward, rotating, and pulling free.

Chapters

  1. 00:10Introduction and Safety
  2. 00:22Confirming Firearm is Unloaded
  3. 00:29Magazine Removal
  4. 00:34Safety Lever Operation
  5. 00:38Racking the Action
  6. 00:55Confirming Unloaded Status (Close-up)
  7. 01:07Dust Cover Removal
  8. 01:18Recoil Spring Assembly Removal
  9. 01:25Bolt Carrier Removal
  10. 01:42Bolt Carrier and Bolt Separation
  11. 01:54Reassembly: Bolt into Bolt Carrier
  12. 01:56Reassembly: Bolt Carrier
  13. 02:13Reassembly: Gas Tube and Piston
  14. 02:36Reassembly: Recoil Spring and Rod
  15. 02:50Reassembly: Dust Cover Button
  16. 02:56Reassembly: Dust Cover Installation
  17. 03:16Final Safety Check and Trigger Test
  18. 03:30Conclusion

Frequently Asked Questions

What are the first steps to safely disassemble a Century Arms N-PAP rifle?

Before disassembling, always ensure the firearm is unloaded. Remove the magazine, slide the safety lever to the 'off' position, and rack the action to confirm it's empty. This is a critical safety step before proceeding with any takedown procedures.

How do you remove the dust cover and recoil spring from an N-PAP rifle?

To remove the dust cover, press the button located on its rear and lift it up and away. Next, compress the recoil spring and guide rod assembly and lift it out of the receiver.

What is the procedure for separating the bolt from the bolt carrier on an N-PAP?

After removing the bolt carrier, press the bolt inward into the carrier, rotate it, and then pull it free. This allows for individual cleaning or inspection of these components.

How is the dust cover secured during reassembly of an N-PAP rifle?

The dust cover is secured by a button on its rear. During reassembly, insert the front end of the dust cover first, then push downward until it clicks into place, engaging this button to keep it secure.

Related News

All News →

More Gunsmithing & DIY Videos You Might Like

More from BurstReview

View all →