Installing the Midwest Industries Rail System on an AK

Published on September 14, 2011
Duration: 7:35

This video provides a step-by-step guide to installing the Midwest Industries rail system on an AK rifle. It covers disassembly, preparation with Loctite and leveling, installation of the lower and upper rails, and mounting a Burris FastFire red dot sight. The process is shown to be straightforward, taking approximately 10-15 minutes with included hardware.

Quick Summary

The Midwest Industries AK rail system can be installed in approximately 10-15 minutes. Key steps include disassembling the rifle, securing it in a vise, leveling the receiver, applying Blue Loctite to bolts, and tightening them in an alternating pattern for proper alignment.

Chapters

  1. 00:00Introduction & Setup Comparison
  2. 01:18AK Disassembly Steps
  3. 02:01Preparation & Leveling
  4. 02:41Lower Rail Installation
  5. 04:18Gas Tube & Handguard Reassembly
  6. 04:39Mounting the Red Dot Sight
  7. 05:53Final Rail Assembly
  8. 06:49Conclusion & Time Estimate

Frequently Asked Questions

How long does it take to install the Midwest Industries AK rail system?

The installation of the Midwest Industries rail system on an AK rifle typically takes about 10 to 15 minutes. All necessary tools and hardware are usually included in the kit.

What preparation is needed before installing an AK rail system?

Before installing the rail, you need to disassemble the AK, including removing the bolt carrier, top cover, recoil spring, gas tube, and handguard. Securing the rifle in a vise and leveling the receiver are also crucial steps.

Should I use Loctite when installing an AK rail?

Yes, it is recommended to use Blue Loctite on the mounting bolts for the rail system. This helps prevent them from backing out due to the recoil generated by the firearm.

How do I ensure the AK rail is installed correctly?

Proper installation involves using a level on the receiver and the rail to ensure they are true. Tighten the mounting bolts in an alternating pattern, similar to lug nuts on a car, to distribute pressure evenly.

Related News

All News →

More Gunsmithing & DIY Videos You Might Like

More from Military Arms Channel

View all →