Wilson Combat Full-Length Flat-Wire Guide Rod Installation (SIG Sauer STX 1911)

Published on October 6, 2018
Duration: 8:02

This guide details the installation of a Wilson Combat full-length flat-wire guide rod on a SIG Sauer STX 1911. The presenter, TheYankeeMarshal, demonstrates a preferred disassembly method and explains the two primary options for upgrading to a full-length guide rod: using a standard guide rod with a coiled spring or a flat-wire specific guide rod with the existing flat wire spring. The latter is preferred for its compatibility with the SIG Sauer's original flat wire setup.

Quick Summary

To upgrade your SIG Sauer 1911 to a full-length guide rod, you can use a standard guide rod with a new coiled spring or a flat-wire compatible guide rod designed for your existing flat wire spring. The latter is often preferred for SIG models as it retains the original spring, simplifying the installation process.

Chapters

  1. 00:10Introduction to Guide Rod Change
  2. 00:46Standard Full-Length Guide Rod Option
  3. 01:14Flat Wire Compatible Guide Rod Option
  4. 01:481911 Disassembly Method
  5. 02:28Removing Guide Rod and Plug
  6. 02:43Spring Plug Comparison
  7. 03:18Installing Flat Wire Guide Rod
  8. 03:40Standard Guide Rod Installation Difference
  9. 04:42Reassembly and Function Check
  10. 05:11Guide Rod Tool Discussion
  11. 05:39Conclusion of Installation

Frequently Asked Questions

Can I convert my SIG Sauer 1911 to a full-length guide rod?

Yes, you can convert your SIG Sauer 1911 to a full-length guide rod. There are two main options: use a standard full-length guide rod with a new coiled recoil spring, or use a flat-wire compatible guide rod designed for your existing flat wire spring.

What is the difference between a standard and a flat-wire guide rod for a SIG 1911?

A standard full-length guide rod requires replacing the original flat wire spring with a coiled spring. A flat-wire compatible guide rod, like the Wilson Combat 25GRFW, is designed with a smaller diameter to work with the SIG Sauer's original flat wire recoil spring.

How do I install a flat wire guide rod on a SIG 1911?

After disassembling the slide, install the flat wire guide rod, then place the flat wire recoil spring onto the guide rod. Reassemble the barrel, spring plug, and then the slide onto the frame, followed by the slide stop pin.

Do I need a special tool to install a full-length guide rod?

While some guide rods have a hole for a tool to manage spring tension during disassembly, the presenter demonstrates a method that does not require this tool. He advises viewers not to be intimidated by the potential need for such a tool.

More from TheYankeeMarshal

View all →