9MM VS 40 HOLLOW POINTS

Published on April 27, 2017
Duration: 4:05

This video compares the penetration performance of 9mm and .40 S&W Federal Premium 135-grain hollow point ammunition against sheet metal barriers. Using Glock 19 and Glock 23 handguns, the test revealed minimal difference in penetration depth between the two calibers, with both stopping around the 9th to 10th plate. The results suggest that for these specific loads and barrier types, the perceived differences in stopping power might be less pronounced than expected.

Quick Summary

Federal Premium 135-grain 9mm and .40 S&W hollow points showed nearly identical penetration performance against sheet metal, both stopping around the 9th to 10th plate. This suggests minimal difference in barrier penetration for these specific loads, contrary to potential expectations.

Chapters

  1. 00:00Introduction: 9mm vs .40 Hollow Points
  2. 00:519mm Hollow Point Penetration Test
  3. 02:01.40 S&W Hollow Point Penetration Test
  4. 03:06Final Comparison & Conclusion

Frequently Asked Questions

How did 9mm and .40 S&W hollow points compare in sheet metal penetration?

In the test using Federal Premium 135-grain hollow points, both 9mm and .40 S&W rounds showed very similar penetration depths against sheet metal, stopping around the 9th to 10th plate. There was no significant difference observed between the two calibers in this specific scenario.

What type of ammunition was used in the 9mm vs .40 S&W test?

The test utilized Federal Premium 135-grain hollow point ammunition for both the 9mm Luger and .40 S&W calibers. Specifically, the Hydra-Shok line was featured, commonly used for self-defense purposes.

Did hollow points penetrate further than FMJ rounds in this test?

The speaker noted that hollow points, in this test against sheet metal, penetrated fewer plates (around 9-10) compared to FMJ rounds which typically penetrate further (up to 12 plates). This suggests hollow points may prioritize expansion over deep penetration against hard barriers.

What handguns were used for the 9mm and .40 S&W hollow point test?

A Glock 19 handgun chambered in 9mm Luger was used for the 9mm portion of the test. For the .40 S&W ammunition, a Glock 23 handgun was utilized, allowing for a direct comparison between the two calibers.

Related News

All News →

More Reviews Videos You Might Like

More from Edwin Sarkissian

View all →