A Glock With Minimum Requirements (And Pr*nt Time)

Published on February 14, 2026
Duration: 17:38

This review examines the MSRG 19, a minimalist 3D-printed Glock 19 frame designed for extreme concealability and rapid production. While demonstrating impressive durability, including surviving being run over by a vehicle, the frame exhibits ergonomic and reliability quirks such as a heavy trigger pull and occasional light primer strikes. The host, with high authority in the 3D-printed firearms community, highlights the potential of FDM printing despite these challenges.

Quick Summary

The MSRG 19 is a minimalist 3D-printed Glock 19 frame designed for extreme concealability and rapid production. Printed in 3.5 hours using Polymaker PLA Pro, it weighs just 4.3 oz with parts. Despite a heavy trigger pull and potential light primer strikes, it shows impressive durability, surviving being run over by a vehicle.

Chapters

  1. 00:00Introduction: MSRG 19 Concealability
  2. 01:13Design Philosophy: Minimalist 3D Printing
  3. 02:58Sponsor: Atrius Development Group FRS
  4. 03:26Build Specs: Aves Rails & Lightweight Frame
  5. 04:44Range Test: Trigger Pull & Reliability Issues
  6. 08:19High Capacity Magazine Testing
  7. 13:22Extreme Durability Test: Run Over by 4Runner
  8. 14:01Final Assessment: 3D Printing Potential

Frequently Asked Questions

What is the MSRG 19 and what are its key features?

The MSRG 19 is a minimalist 3D-printed Glock 19 frame designed by Unseen Killer. It prioritizes extreme concealability and rapid production, using minimal material, featuring a skeletonized grip, and lacking a traditional trigger guard. It weighs only 4.3 ounces with lower parts installed.

How durable is the MSRG 19 3D-printed frame?

The MSRG 19 demonstrates remarkable durability. It successfully handled rapid fire with extended magazines and famously survived being run over by a Toyota 4Runner, remaining functional immediately after the test.

What are the potential reliability issues with the MSRG 19?

Initial testing revealed a very heavy trigger pull (estimated 12-30 lbs) and occasional light primer strikes. These issues may stem from rear rail fitment problems causing the slide to shift during the trigger pull.

What materials and components were used in the MSRG 19 build?

The frame was printed using Polymaker PLA Pro in about 3.5 hours. The build incorporated a standard Glock 19 lower parts kit, Aves front and rear rails, and a heat-treated machined locking block.

More Reviews Videos You Might Like

More from PSR

View all →