Colt’s Dragoon: Accuracy

Published on July 19, 2021
Duration: 6:38

This video details accuracy testing of a Uberti 3rd Model Dragoon revolver using varying powder charges. The instructor demonstrates loading procedures with 30, 40, and 50-grain charges of Go-X powder, .454 diameter round balls, lubricated felt wads, and Remington #10 caps. Results show sub-two-inch groups at 15 yards, with the 50-grain charge performing surprisingly well. The importance of fine-tuning powder loads for optimal accuracy is emphasized.

Quick Summary

Accuracy testing of the Uberti 3rd Model Dragoon revolver at 15 yards revealed that 30-grain powder charges yielded sub-two-inch groups, while 40 and 50-grain charges produced groups just over or around two inches, respectively. The firearm consistently shot high, a common trait for Colt designs.

Chapters

  1. 00:00Introduction & Test Setup
  2. 00:56Loading with 30 Grain Charge
  3. 02:09Target Results: 30 Grain Charge
  4. 02:53Loading with 40 Grain Charge
  5. 04:00Target Results: 40 Grain Charge
  6. 04:21Loading with 50 Grain Charge
  7. 06:38Target Results: 50 Grain Charge
  8. 06:02Fouling & Wad Performance
  9. 06:15Conclusion & Recommendations

Frequently Asked Questions

What powder charges were tested for accuracy with the Uberti 3rd Model Dragoon?

The accuracy test involved three different powder charges: 30 grains, 40 grains, and 50 grains of Go-X (Triple FG) powder. These were used with .454 diameter .44 caliber round balls and lubricated felt wads.

What were the accuracy results for the Uberti 3rd Model Dragoon at 15 yards?

At 15 yards, the 30-grain charge produced a sub-two-inch group. The 40-grain charge resulted in a group just over two inches, and the 50-grain charge achieved a group of approximately two inches or slightly under.

Does the Uberti 3rd Model Dragoon shoot high or low?

The Uberti 3rd Model Dragoon, consistent with Colt designs, tends to shoot high. The shooter compensated by aiming at the bottom of the target rather than the bullseye during the accuracy test.

How do lubricated felt wads affect bore fouling in black powder revolvers?

Lubricated felt wads are shown to be effective in minimizing bore fouling, even when not cleaning the barrel between firing groups. This helps maintain consistent performance during extended shooting sessions.

More Range & Competition Videos You Might Like

More from Guns of the West

View all →