Modifying Glock with 3.5lbs Connector/Timney Trigger...Before and After Comparison!

Published on March 22, 2023
Duration: 10:36

This guide details the process of modifying a Glock 20 Gen 5 by replacing the trigger connector with a 3.5lb version and installing a Timney flat face trigger shoe. The video demonstrates the disassembly, part replacement, and reassembly, followed by a before-and-after trigger pull weight comparison. The modification resulted in a significant reduction in trigger pull weight, from approximately 5 lbs 10.5 oz to 3 lbs 10.1 oz.

Quick Summary

Modifying a Glock with a 3.5lb trigger connector and a Timney flat face trigger shoe can significantly reduce the trigger pull weight. This upgrade can change the pull from approximately 5.5-6 pounds down to around 3.5-4 pounds, offering a lighter and potentially crisper feel.

Chapters

  1. 00:00Introduction & Project Overview
  2. 00:18Yankee Marshall Intro
  3. 00:26Glock 20 Gen 5 Modification
  4. 00:45Trigger Weight Comparison Request
  5. 00:54Installing Timney Trigger Shoe
  6. 01:13Disassembly Begins
  7. 01:39Removing Glock Pins
  8. 02:08Removing Trigger Block
  9. 02:35Changing the Connector
  10. 02:59Replacing the Trigger Shoe
  11. 03:42Installing New Trigger
  12. 03:57Reassembly
  13. 04:15Testing Functionality
  14. 04:47Trigger Pull Weight Test
  15. 04:51Stock Trigger Pull Weight
  16. 05:05New Trigger Pull Weight
  17. 05:18Results & Conclusion
  18. 05:39Channel Support & Merchandise
  19. 05:55Live Chat Information

Frequently Asked Questions

What is the typical trigger pull weight for a stock Glock?

A stock Glock firearm typically has a trigger pull weight around 5.5 to 6 pounds. This video demonstrates a stock Glock 20 Gen 5 averaging 5 pounds, 10.5 ounces before modification.

How much does a 3.5lb connector reduce Glock trigger pull weight?

Installing a 3.5lb trigger connector, along with a trigger shoe upgrade, can significantly reduce the trigger pull weight. In this video, the modification resulted in an average pull weight of 3 pounds, 10.1 ounces, a reduction of over 2 pounds from the stock configuration.

What tools are needed to replace a Glock trigger connector and shoe?

To replace a Glock trigger connector and shoe, you will typically need a punch block, a punch set for removing pins, and a small screwdriver for adjusting the trigger shoe screw during installation.

Is it difficult to install a Timney trigger shoe on a Glock?

Replacing a Glock trigger shoe, like the Timney model shown, requires careful disassembly and reassembly. While not overly complex, it demands attention to detail, especially when aligning the trigger bar with the new shoe and adjusting the retaining screw.

More Gunsmithing & DIY Videos You Might Like

More from TheYankeeMarshal

View all →